I need to replace one of the ball joints on my LSR a arms. Do I need to order it from LSR or is there some place else I can get them? How much do they cost normally?
I need to replace one of the ball joints on my LSR a arms. Do I need to order it from LSR or is there some place else I can get them? How much do they cost normally?
2002 yellow 416ex
Ross Piston 11:1 compression
Hotcams stage 2
Porting
Spark's X-6 exhaust
FCR 39mm carb
165 main jet/ 52 pilot jet
LSR +2 A-arms
LSR +4 axle
Elka tripple rate fronts
Derisi rebuild rear shock
Spark's rev limiter
K&N Filter/Outerware
Tinner Air Scoop
Holeshot XCR on stock rims
Tag T-2 handlebars
LSR uses a 16mm diameter shaft and unless you get lucky and get a parts store to match it you will need to get it direct from LSR.
Staff Photographer ATVRiders.com
Senior Photographer ATVInsider
Staff Photographer GNCC Racing/ATV MX
Staff Photographer Vurboffroad
Staff Photographer Cycle News
Lonestar uses a 79 ford courier tie rod end for a ball joint.
2006 LTR450 Almost stock and love it.