View Full Version : starting problem

08-15-2005, 07:56 PM
For a while now its been hard to start. I always have to jump it to get it running and it still takes a long time to even do that. Even with it being jumped it sounds like its not getting alot of power to turn over. And now it wont start at all the starter will just whine but it wont turn over. Any ideas would be appreciated.....Thanks

08-15-2005, 08:30 PM
Your starter is shot!

08-15-2005, 08:54 PM

08-17-2005, 05:47 PM
Starter spins and engine doesnt crank? One way bearing might need replacement.

08-17-2005, 09:22 PM
Its the oneway.I have the same problem.Needs complete teardown

08-17-2005, 10:30 PM
no it started and was running and hen shut off and tryed to start it again and then the starter just started to whine and that was it

but its been hard to get started for a while now

08-21-2005, 04:58 PM
If the starter spins and the engine does not then your one way is out or the starter clutch is slipping . Easy to check . Pull the starter clutch cover and see if it spin in one direction and not the other.