Originally posted by SuzukiRacr07
it sits lower, it has more travel, it has more compression, it is a DOHC, it has titanium valves, there is just so much stuff the TRX doesnt hav that the YFZ does..... YFZ ALL THE WAY!!!
You obviously don't know much of what you are talking. It may sit lower. More travel doesn't mean better susupension and it is a VERY small margin of travel between the two. More compression doesn't mean anything either in itself. It take a lot more than compression to make an engine run and the TRX is supposed to have as much or more power with less compression. That means it has more room to make more when modded. DOHC doesn't mean much either. If the valves are opening and closeing at the same time with a DOHC engine as an exact same SOHC engine the SOHC engine will probably rev a bit quicker due to less rotateing mass. This is one of the reasons Honda went with the Unicam design. It isn't inferior by any means to a DOHC engine. I haven't heard on the TRX but I'm about 90% sure the CRF has Titainium intake valves and stainless exhaust valves. This is because Titanium absorbes heat to well and won't let it go. So they don't use them on the exhaust side for reliability reasons. If you are so concerned aobut electric start then you must not really want a race bike. Electric start is for wusses. I get sick of hearing everyone (mostly the YFZ guys) complaining about no electric start. WAAAAA. So I guess when it comes down to it all you got is a lower bike. So I guess just because it is lower it is better? I don't think so. Bottom line until it comes out NOONE will know wich one is better and I bet they are really close. It will probably come down to brand loyalty or color preference. But you don't see Honda makeing a blue one to try to steal sales like Yami makes a red and white one. Anyway I'm off to go ride my 400 until my 450 gets here.
'04 TRX450R now here!!! Have Sand Stars front and rear. AC nerfs on the way along with HRC kit and Factory Effex graphics kit!
'02 TRX400EX for sale. Emaculate!!!E-mail me if you are interested.
'86 ATC250R Paul Turner HR pipe, Fat Boy silencer, Boyseen reeds, 39mm Mikuni Flat slide, K&N air filter, ported, CR250 Head Gasket.