If you have one let me know. U571@ suddenlink. Net
If you have one let me know. U571@ suddenlink. Net
If you cant beat it, Shoot it.
2010 oultaw 90, CDI and PIPE.
03 KFX 80 stock with 6''+ arms.
use an lt80 needle &seat...
I have a whole carb off of a 03 Predator 90. Will that help
Proud Dad of Briannah "Breezy" James #05
Jr Pee-Wee LSQR 2013 Champion
Sr Pee Wee for 2014
Thanks to her 2014 sponsors
G-Force Powersports
Hedgehog ATV
Fly racing
Motowoz
Scott Goggles
Leatt
Amsoil
Braap Bling
I was able to drill the seat out and flow enough gas. It lasted about 3 min before I burned a hole in the piston. I believe the octane was too low for the larger piston and High compression head.
If you cant beat it, Shoot it.
2010 oultaw 90, CDI and PIPE.
03 KFX 80 stock with 6''+ arms.
I would look at replacing the carb with a kehin pwk 28mm d-slide.Also you are going to have to go up to some higher octane fuel.I would do no less than hand mix some 110 octane fuel with amsoil dominator 50-1 at least.To much oil will cause detonation and will blow a hole in the piston.
TS RACING
Tanner Sorrow #12
90 OPEN
90 AUTO SENIOR
Thanks to Tom and Atv 4 Play
Thanks to Norris@ Quinn Motorsports
2012 DURHAMTOWN BOMBER/PEEWEE 70CC CHAMPION
2013 DURHAMTOWN PEEWEE 90CC CHAMPION
2014 DURHAMTOWN BOMBER 90CC CHAMPION
I have another person saying it was likely the oil injection was not working.
If you cant beat it, Shoot it.
2010 oultaw 90, CDI and PIPE.
03 KFX 80 stock with 6''+ arms.
Burning to much oil(what oil injections cause these little engines to do) causes detonation which causes holes in pistons.Oil injection not working would likely cause the motor to lock up before it would put a hole in the piston.This is just coming from my past experiences
TS RACING
Tanner Sorrow #12
90 OPEN
90 AUTO SENIOR
Thanks to Tom and Atv 4 Play
Thanks to Norris@ Quinn Motorsports
2012 DURHAMTOWN BOMBER/PEEWEE 70CC CHAMPION
2013 DURHAMTOWN PEEWEE 90CC CHAMPION
2014 DURHAMTOWN BOMBER 90CC CHAMPION