please to let me know if it works or not
i know that they have the same numbe of spline(24) but the pitch are different so its why im asking this
please to let me know if it works or not
i know that they have the same numbe of spline(24) but the pitch are different so its why im asking this
Yes but only if they are used hubs, the splines are slightly too thick otherwise. Even so dont do it.
If it's stupid, and it works, it isn't stupid. - Murphy's Law
2000 426EX,sold
2004 450R WIP
-Longtime A.A.D.S. (Accessory Acquisition Disorder Syndrome) sufferer.
400EX Frequently Asked Questions, CHECK HERE FIRST!
ok cause a have a 400ex and was willing to buy tire and rims that came with the raptor because of the bolt pattern. the guy give me a good price so i dont know if i should try because the hubs are used so..
Its your call....
If it's stupid, and it works, it isn't stupid. - Murphy's Law
2000 426EX,sold
2004 450R WIP
-Longtime A.A.D.S. (Accessory Acquisition Disorder Syndrome) sufferer.
400EX Frequently Asked Questions, CHECK HERE FIRST!
so you say that they will probably wont fit?
If it's stupid, and it works, it isn't stupid. - Murphy's Law
2000 426EX,sold
2004 450R WIP
-Longtime A.A.D.S. (Accessory Acquisition Disorder Syndrome) sufferer.
400EX Frequently Asked Questions, CHECK HERE FIRST!
try it and let us know if it works. you can always sell the hubs and wheels if it dont work.
The yamaha hubs are like the 250r. If you put them on a 400ex you will loose 2 or 3 inches of width.
I have a question regarding a 400 and a raptor. A buddy needs new rear tires on the yami, I couldn't find any for him so I was going to sell him my wheel/tire combo rears. I thought they were all 4/110, Found out quick raptor is 4/115.
The problem is, My tires and wheels are new and we used a chit ton of bead seal on them so im kinda worried about un-mounting them for the yami wheels. I read you can drill out the 400 wheels with a 1/2" bit and maybe some filing and they will fit. Is this true? has anyone done it?
I don't want to ruin a set of wheels if it wont work, But I have read many opinions on it and they say it works. Anyone by chance do this and or try and fail?