hey guys,
Just bought a gt thunder rear swing arm guard with the two alumiun plates and plastic rotor guard. I was just wondering if i had to pull the whole axle out of it and put it on or just take of the sproket and slind on everything.
hey guys,
Just bought a gt thunder rear swing arm guard with the two alumiun plates and plastic rotor guard. I was just wondering if i had to pull the whole axle out of it and put it on or just take of the sproket and slind on everything.
2018 Sponsors
AJ Connors Racing, GBC Motorsports, Scott Goggles, Bell Helmets, O’Neal, Houser Racing, HMF, IQ Defense, Rekluse Clutches, IMS, Hot Cams, Cylinder Works, Hot Rods, Pivot Works, Vertex Pistons, All Balls, Leatt, Powermadd, Fasst co, Quad Tech, Amsoil, Sunstar Chain and Sprockets, BTO Sports
Quad History
2016 YFZ 450R
2014 YFZ 450R
2012 YFZ 450R
2010 YFZ 450R
2010 YFZ 450X
2009 YFZ 450r
2008 YFZ 450
1996 Polaris Scambler 400
1995 Polaris Magnum 425
if u have the dual sprocket guard then u will just need to take the chain loose or off then unbolt the sprocket everything should just fall into place. i have the single sprocket guard because if u run the dual guard u have to get a guard dog sprocket cleaner which is another money pit. i have the poly rotor guard also. just bolt it right on and use some washers to space the right side down to clear the rotor but it will wear into the guard as its suppose to as stated in the directions.
hope that helps