hey guys.. heres some pictures of some things i had powdercoated. the cases and oil tank are semi glass and everything else is gloss. enjoy! oh yea, i'll have it all installed tomorrow!
hey guys.. heres some pictures of some things i had powdercoated. the cases and oil tank are semi glass and everything else is gloss. enjoy! oh yea, i'll have it all installed tomorrow!
~Mike~
2000 Honda 416EX
shiny...
~Mike~
2000 Honda 416EX
the only problem is that they didn't take the plugs out of the left case.. i asked them to since i didn't have the tools at school and i forgot to do it at home... anybody know how i can get it to break free without chipping it?
~Mike~
2000 Honda 416EX
Just install the covers and then remove the inspection plugs. You should be ok.....but they should have been removed before they coated them
Staff Photographer ATVRiders.com
Senior Photographer ATVInsider
Staff Photographer GNCC Racing/ATV MX
Staff Photographer Vurboffroad
Staff Photographer Cycle News
thanks for chiming in pappy, i was hoping you would. im kinda concerned about the o rings too.. although the engine gets hot itself. i'll just see how it works tomorrow evening! i wish i would have gotten the exhaust end cap coated in trans or candy red. the tip is staying the aluminum color.
~Mike~
2000 Honda 416EX
well you need to get the inspecton plugs out and make sure no grit from prep is hiding there and that the oil rings are intact and werent damaged. You run sanding grit through the engine and you wont be happy. this is why we disassemble everything here for people that dont know atvs/motorcycles etc.
Staff Photographer ATVRiders.com
Senior Photographer ATVInsider
Staff Photographer GNCC Racing/ATV MX
Staff Photographer Vurboffroad
Staff Photographer Cycle News
these are going to have to get a good cleaning before they're put back on. theres sand in little crevices everywhere. oh well, it'll give me something to do haha.
~Mike~
2000 Honda 416EX
wow looks great man!
what did this run u in price after shipping and everything?
2007 Honda Trx 400ex
-HMF Carbon Fiber Bill Ballance Pro Series Full Exhaust.
-K&N Filter.
-Sparks Timing Key.
-Jetting 155 Keihin Main Jet.
#42 Pilot Jet.
- Blingstar Bumper.
- Pro Armor Nerfs.
a local company (local to my school) did it and it was $100 even.
~Mike~
2000 Honda 416EX
Looks great! Cant wait to see it done.
~Dallas~
03' Roll Design/IMS-Roll/Custom Axis/C&D Racing 416ex
Special thanks to...
Colby@C&D Racing
Hardkor Engineering
G4 Graphics
Team2powersports
RockyMountain ATV
Chino886
K&K ATV
JL ATV
Magic Racing
Blais Racing
Metro Powersports
IMS/Roll Design
Motosportoutlet
Badger Cycle
And To my wife
Motor mods- JE 11:1 comp,Stg 2 Hotcam,C&D Race ported head,Stock carb jetted,White Bros pipe. Ran on Turbo Blue 110