Remove wheel
Remove 2 brake caliper mount bolts and set caliper aside
Remove large spindle nut
Tap rotor and hub assembly off spindle
Remove wheel
Remove 2 brake caliper mount bolts and set caliper aside
Remove large spindle nut
Tap rotor and hub assembly off spindle
Staff Photographer ATVRiders.com
Senior Photographer ATVInsider
Staff Photographer GNCC Racing/ATV MX
Staff Photographer Vurboffroad
Staff Photographer Cycle News
Yes, it is not hard to do. Another tip, if you plan on takling the rotor off, sometimes it is easier to do while the hub assembly is still attached to the spindle. becareful, the allen head bolts do not like coming out and have threadlocker installed from the factory.
Staff Photographer ATVRiders.com
Senior Photographer ATVInsider
Staff Photographer GNCC Racing/ATV MX
Staff Photographer Vurboffroad
Staff Photographer Cycle News
finally! i needed help with this before
thanks!
what about getting the race out?
Unless you have a set of hubs I have not come across, there is no race in the majority of atv front hubs, just sealed ball bearings.
Staff Photographer ATVRiders.com
Senior Photographer ATVInsider
Staff Photographer GNCC Racing/ATV MX
Staff Photographer Vurboffroad
Staff Photographer Cycle News
How do you know if your bearings are bad?
'02 Red 400
It's faster now then when I bought it!
If you want to see how the bearings are, pull the hub, the small spacers and the seals. Stick your finger inside the bearing and turn it, it should turn free and smooth. If its hard to turn or feels notchy, replace themOriginally posted by Doibugu2
How do you know if your bearings are bad?
Staff Photographer ATVRiders.com
Senior Photographer ATVInsider
Staff Photographer GNCC Racing/ATV MX
Staff Photographer Vurboffroad
Staff Photographer Cycle News
with my wheels off, its kinda hard to spin my hubs, do i need to replace my bearings?
Cody
99 416ex *sold*
2008 Yfz 450
no its your brake pads still grabbing the rototrs a little. its normalOriginally posted by 400exrules
with my wheels off, its kinda hard to spin my hubs, do i need to replace my bearings?
What if both bearings are the same size-86 250R? I tried prying one of them up a little to get a punch in so I could beat it out, but I"m not having any luck. Is there a trick I'm missing, or do I need some special tool? Also, is the bushing in the middle really important as it got a little scratched-I planned on sanding it a little and reusing it? Thanks for any help or advice, I've had nothing but problems with this R since I traded a shee for it.
On bearings that are the same size, I usually try and get the spacer moved to one side so I can get a punch down through the bearing and onto the lip of the other bearing.
Staff Photographer ATVRiders.com
Senior Photographer ATVInsider
Staff Photographer GNCC Racing/ATV MX
Staff Photographer Vurboffroad
Staff Photographer Cycle News