Well im still new to the CVT world and I have a issue that I would like some opinions on. I have a DRR 50 (built team mhr malossi) that im having a bogging issue. It starts right up, idle's no problem and when you hit the throttle it rips out of the hole then after about 3 seconds it starts bogging down like you have your foot on the brake. It was running great and then just started doing this without changing anything. I pulled the clutch and everything apart inspected (no defects that I could see), cleaned and reassembled. The trans rolls freely with no binding that I could feel. I also put it on a stand held it pinned and it didn't seem to have the problem but I may not have held it long enough. running 3.25 rollers, stock variator with new slides, 78x16x30 PL 30206 belt, stock clutch with red shoe springs and I believe a 1500 maybe 2000lb (numbers are wore off) torque spring. Any help is much appreciated