DYNO jet ket HELP ASAP
HONDA TRX450R
Okay reading through the instructions for this jet kit the last step for the stage two says the following;
"6. Locate the Fuel Mixture Screw (Fig. D). Using a flat blade screwdriver, turn the mixture screw clockwise untill it seats, then turn out 2.5 turn, 2 turns above 5,000 feet."
So my question is, if I'm going to be riding below 5,000 feet do I have to mess with that needle valve???????
Because I'm not above 5,000!!!!
Thank you.
Also in the instruction it mentions about installing the DYNO jet kit on groove#3 for applications under 5,000 feet. It does not show or say where "groove #3 is."
Thanks
***2005 450R***
-13tooth pinion
-8 Paddle Haulers on .190 RED dots
-Mohawks Skat Traks on .125 Blue dots
-Stage two DYNO JET KIT
-Performance Desighn w/K&N
-Outerwears Pre Filter
---------------------------------
Wish List
-HMF Pipe
-HRC Kit, Or HOTCAMS