Jetting my FCR
I have a 41mm FCR on my stroker motor. Engine was dyno with "the right" jets and produced decent power. but jetting is definitally off. It sputters and surges down low to maybe 1/4 throttle then cleans out. Dyno was ran with this in the test description. fcr carb ocemr #5 182m 48p. But i dont know what the ocemr #5 means, maybe needle clip. I think my pilot may be too lean. but im not sure. quad puts out 52.6HP and 37.5lb-ft tq. not bad but expected the numbers to be more opposite. Dyno sheet to come. but need suggestions on jetting.
05 TRX 450R Long travel
01 465EX with lots of goodies SOLD
05 F350 SD 4x4 Lifted