2004 TRX400EX: would appreciate suggestions on a rebuild kit or components to rebuild axle and all associated bearings for rear end of quad.
Thanks in advance!
|
|
Registered User
2004 TRX400EX: would appreciate suggestions on a rebuild kit or components to rebuild axle and all associated bearings for rear end of quad.
Thanks in advance!
2004 trx 400ex
Pro Armor
K&N
Cycra hand guards
Trail Tech in billet
Armadillo out-n-back rack
FMF ti-4 anodized
EHS Racing air box lid
Sand Sharks for sand
and a BIG SMILE!
Registered User
Crickets! Calling ALL BALLS for recomendations.
2004 trx 400ex
Pro Armor
K&N
Cycra hand guards
Trail Tech in billet
Armadillo out-n-back rack
FMF ti-4 anodized
EHS Racing air box lid
Sand Sharks for sand
and a BIG SMILE!
BBBRRRAAAPPP
This place is pretty quiet these days. The book of faces I hear is the happening place to be.
You need a new carrier if the bearings are bad. It isnt worth trying to swap them out unless you have a slide puller. The carriers are less than 100 bucks online. All balls is fine, id suggest the swingarm bolt and bearings as well, they are not a fun job however. The bolt often gets stuck, hope you got in impact gun.
If it's stupid, and it works, it isn't stupid. - Murphy's Law
2000 426EX,sold
2004 450R WIP
-Longtime A.A.D.S. (Accessory Acquisition Disorder Syndrome) sufferer.
400EX Frequently Asked Questions, CHECK HERE FIRST!
Registered User
Thanks for the reply sir! Will investigate a new carrier.
2004 trx 400ex
Pro Armor
K&N
Cycra hand guards
Trail Tech in billet
Armadillo out-n-back rack
FMF ti-4 anodized
EHS Racing air box lid
Sand Sharks for sand
and a BIG SMILE!
Posting Permissions
Reply With Quote