Results 1 to 4 of 4

Thread: tranny problem

  1. #1
    Join Date
    May 2013
    Posts
    32

    tranny problem

    my primary tranny gear (the one that attaches to the front sprocket) moved off of the shaft a lil bit making it really hard to turn. I replaced that part and everything spins freely until I get the allen bolts tight, then I cant turn it at all. the other gears look good. does this mean I have an issue with the other gears. am I tighten it too tight? im reusing the gasket, is that the problem. I just don't get it.

  2. #2
    Join Date
    Jan 2014
    Location
    NE Ohio
    Posts
    22
    The gears are tough to turn when assembled. put the sprocket on and see if you can spin it, it will probably still be tough.

  3. #3
    Join Date
    Mar 2009
    Location
    cherry valley
    Posts
    956
    its not the gasket
    you are not over tightening either
    when apart all bearings move freely ?
    is that gear facing same way ?
    and is it in the exact position ?
    take all other gears out and assemble with just repaired shaft torque it ,does it bind ?

  4. #4
    Join Date
    May 2013
    Posts
    32
    turns out tranny was fine all along its just that hard to turn by hand. whoops ha

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •