Im just now getting around to replacing my tie rod's and end's. I bought the 12mm ASR ones IIRC but the are the male ends vs stock. Any who, My question is, I will most likely be doing this alone and what is a good run of the mill toe-in from rotor to rotor on a stand?

I just plan on taking off one side and using it as a starting point and when both are done set it at 1/32-1/8" in per side. I tried the search and sticky but wondering what to set without me being on to 'dial' in. Plus do the old TRE's fall out with a hit of a hammer, Puller or ??. Thanks for any help