bypass

[Holy Kaw!]

You can bypass the roll over sensor and just get rid of it completely.

The brown wire on the roll over sensor will be used as a ground, just ground it to the frame.

You're left with a blue and yellow wire, just tie those two together an bam you're done by completing the circuit without the sensor.

Bypassed an will never shut off again if you go through a real bumpy section.

[joep1219]

i know this is an old thread, but i have tried this and still no luck. i don't know if the wire colors are mixed up or if this even works?... i can't trust the silicone trick anymore! i would like to bypass the switch all together. i see that kms has a eliminator, but that is just one more connection that i would like not to have.
if any one has any logical suggestions please help!

thanks, joe p.