can anyone tell me what radiator they run in the jbmods?, i need one for a cr85 motor, i have one for the crf150 motor but the outlet comes out straight, right into the pipe. and the inlet comes out at a 90 right into the frame. thanks
can anyone tell me what radiator they run in the jbmods?, i need one for a cr85 motor, i have one for the crf150 motor but the outlet comes out straight, right into the pipe. and the inlet comes out at a 90 right into the frame. thanks
David Fairchild #521 2012 (50 production & 70 production)
Daniel Fairchild #807 2012 (90 mod)
David 2011 D14 50 Limited Champion
Daniel 2011 D14 70 Prod. 2nd place
Thanks to Fierce Powersports!!
I know a lot of guys run the YFZ 450 radiator in there minis. They are pretty cheap on eBay . Even new ones are cheap. Don't know about inlet and out configuration we are still running a air cooled four stroke. Check the YFZ out , hope this helps.
Adam McGee Racing 11 running 2 Pitster Pro's and a Xtreme custom flat tracker. Thanks Firepower Minis, Tbolt Usa, Atv Fourplay, Pitster Pro BRM Offroad graphics, Titain Motorworks , Motocross Vests Champions Choice
Moto X Outcast 2012 90cc 3rd place
Steve Nace Indoor Winter Nationals St and TT 2011-2012 and 2012-2013 2nd place.
i think the yfz is what i have, and i think its an oversize aftermarket, so i'm also concerned that it might be to big and not let the coolant heat up enough.
David Fairchild #521 2012 (50 production & 70 production)
Daniel Fairchild #807 2012 (90 mod)
David 2011 D14 50 Limited Champion
Daniel 2011 D14 70 Prod. 2nd place
Thanks to Fierce Powersports!!
a trx250r radiator is used in allot of the fischer/jb mods we have seen and also is what we use for our jb mod with cr85 motor. Just an fyi on the 250r radiator the 86/87 is slightly different than the 88/89 versions. The outlet at bottom goes down and other goes down and curves for lower coolant hose which should give you the clearance you need to get lower than the pipe. a 250r will use 2 upper brackets where the mounts are built into a yfz radiator so might need to make some brackets but they are basicly just a 90 degree bent aluminum bracket.
thanks doonan that sounds more like some of the pics i've seen
David Fairchild #521 2012 (50 production & 70 production)
Daniel Fairchild #807 2012 (90 mod)
David 2011 D14 50 Limited Champion
Daniel 2011 D14 70 Prod. 2nd place
Thanks to Fierce Powersports!!
The older JB chassis used a 250r radiator. Anything from the last 5 yrs or so uses a yfz450 radiator. Most people use a 90 degree bent hose coming out of the radiator. If you don't have room between that and the pipe on your 2 stroke, have a shop cap off the factory nipple and install a new one on the 45 degree angle of the radiator tank bottom.