I have a keihin FCR 39mm for my 2006 outlaw 500 I was wondering if anyone has done this swap and what mods do you have? Also what are your jet sizes? Thanks
I have a keihin FCR 39mm for my 2006 outlaw 500 I was wondering if anyone has done this swap and what mods do you have? Also what are your jet sizes? Thanks
2006 Outlaw 500
K&N filter outerwear/box delete
FCR 39mm mx carb jetted
Trinity slip-on stage 4
Pro armor nerfbars
2007 Outlaw 525
Stage two web cam
Behive valve springs
ported polished head
K&N filter outerwear/box delete
Duncan racing fatboy 4 full header/slip-on
Procom CDI
AMR coil
When in doubt gun it!!!
I used to run one on my old Predator, which uses the same stock carb as yours, But mine was off of a KTM bike I believe, the predator carb to airbox tube was bigger than the outlaw, and the carb I used had a bigger bell on it that fit great. You may have to get an adaptor for the bell of your carb. I know DASA sells them for the guys who run FCR's on the 04/05 450R's. I think there are some adaptors on Ebay and stuff too, NOS maybe?
I also had to have motion pro build me a throttle cable, but now days I'd bet a stock KTM engined Outlaw cable will get it done.
As far as jetting, I don't recall exactly, but it was about a 185mj, and 48 pilot. I had a 558 kit, a Rath billet intake with the open K&N, and a Nicholas ported head. Hopefully that gets you in the ballpark.
By the way, the FCR was one of the best mods I ever did to mine.
"I WANNA GO FAST"
Thanks for the info I actually bought the throttle cable from the KTM outlaw. Now I'm hunting down the carb spacer.
I've also heard the carb swap was a huge improvement over stock.
Next is a big bore kit just not sure which one.
2006 Outlaw 500
K&N filter outerwear/box delete
FCR 39mm mx carb jetted
Trinity slip-on stage 4
Pro armor nerfbars
2007 Outlaw 525
Stage two web cam
Behive valve springs
ported polished head
K&N filter outerwear/box delete
Duncan racing fatboy 4 full header/slip-on
Procom CDI
AMR coil
When in doubt gun it!!!