here is a er with key installed, green wire mod, fan installed,and 24volt start, with teather and push button start.Tors bypassed
*for a ER to R conversion go to page 5 last pic on page
EDIT the one thing to remember before any wiring is there are many ways to do the same thing.. do what is easiest for you!!
and remember that Honda's grounds are small,
to compensate for this they use multiple greens, if you remove to many of the greens, you will have corrosion issues, caused by poor impedance to ground, leave in as many grounds as you can to avoid this!!!
and here is a 06 up with absolutely every thing except the TPS removed, this is about as bare as you can run, it does have teather , this is full race no frills.. no tors
Great post ! I cut my harness on Saturday and it's pretty similar to your Bare Race one, but mine has also Temp. sensor and Fan Motor. I wired red wire straight from the rectifier to the fan, cuz I have no Condenser.
the only issue without the condenser,unless it has a battery is at idle your fan will be slow, and speed of the motor will control speed of the fan... and you might shorten the life of the fan motor with all the surges, but the reg/rec might help