This is the stock fittings, like i said before you have to grind the clamps to seperate these from the stock rubber hose, pretty simple to do just wear your goggles
These particular two come from the hose that runs from the bottom end of the motor to the bottom of the oil tank
A 8AN SS Braided hose fits pretty snug over these two fittings, rubber ones more snug than teflon ones
you will need 1/2" worm clamps to seel them on, or atleast that is what i used
im going to be uploading alot of pics on this thread, so they will keep coming
This is what i used to cut my hoses to my desired length
keep in mind guys whenever you are building custom hoses, you need to do a mock up
i put the stock fittings in there spots, then laid the hose across them to see what length i needed, dont just go cuttin ****, cuz you might cut it to short then you will have to get another hose!
This black piece is the bracket i made to connect it to the stock mounting points, i just used some cheap sheet metal and cut it to fit, i still need to make brackets to secure it from the bottom
The pink circles is where it is bolted to the cooler
The yellow circles is where it bolts to the stock points on the frame
The white circles are the mounting tabs that hold the spal fan onto the cooler
I might make another bracket the same shape again outta better metal tom.