Frequently asked 450R questions/thread!s

[DnB_racing]

Originally posted by hondaxcracer
how about a 05 to 06 motor swip? does the 05 carb plug in to the 06 hardness?

the 05 doesnt have a connector for the TORS, but does have the tps connector...

I think the 2 tps connectors are different, but I forget... but it wouldnt be hard to swap connectors if needed, both use the same style pin inside the connectors


the pins inside the connectors can be removed with a solid leather sowing needle
on the pins there is a small fin that can be compressed to release it from the connector... slide the sowing needle between the pin and connector and you can usually pull out the pin from the connector

I hope I made that understandable??lol

[dantrx038]

does 06+ aem a-arms will fit on my 05?

[grant14]

the a-arms will fit but the hubs are different. so you would have to have a set of 06+ hubs to go with them.

[ben 22ltr]

Will 400ex a arms fit on a 05 450r?

[Scro]

Originally posted by ben 22ltr
Will 400ex a arms fit on a 05 450r?

No, the distance between the mounting points is different.

[rollie]

If anyone has info thats not already on the first page or info they would like posted post it here or PM me, This post may be 3 years old but i'm still lurking the forums

[tritty_wall]

does anyone have a picture of the Green wire and Tors mod? I just don't want to start cutting wire until I know for sure what I'm doing. I Get that i just have to cut the green one just not sure which end go where when doing the tors like DnB_racing has explaned.

Thanks, Tristin

[DnB_racing]

does anyone have a picture of the Green wire and Tors mod? I just don't want to start cutting wire until I know for sure what I'm doing. I Get that i just have to cut the green one just not sure which end go where when doing the tors like DnB_racing has explaned.

Thanks, Tristin

http://www.google.com/url?sa=t&rct=j...INj2lXli2S2nqg

ok that's obviously the green wire mod....

now instead of isolating both sides of the green just isolate the cdi side
now on that same connector there is a grey/red wire-cut it
take the green from harness side and splice to grey/red from cdi side
isolate the harness side grey/red wire and you've bypassed the carb safety at the closest possible point

use heat shrink and solder for your connections tape over and its done

3 minute job tops.... simple

[rollie]

Wow i made this 5 years ago haha.....i hope it's helped some people i still have a 450r! Haha