where can i download a diagram of the carb 08 grizzly 4x4 450? before i tear it apart.
where can i download a diagram of the carb 08 grizzly 4x4 450? before i tear it apart.
livin on the edge cause there`s no room left in the center.
05 400ex
trail tech gold bars/logo clamp mounted 50w autolights
itp gncc tires/stock rims
rk gold xw chain/jt sprockets
alba racing steering stabilizer
red skull moto grips
full hmf yellow system
yellow/red flame shock wears
hmf carbon heat shield
fully jet and tuned carb
tusk hand guards
tusk block off plate
all balls axle/wheel bearing
dg full nerf bars
pro armor bumper
450r shocks
engine mods to come
Bored to 406
Port and polished heads
Complete top-end rebuild
All new, better than brand new!
I think that carb is harder to get on and off than to take apart. There aren't that many pieces, just write some notes or draw yourself some diagrams so you make sure you put everything back where it came from. Read the numbers on the jets to make sure they go back in the right place. There are only 3 jets and you can only mix up 2 of them. The hardest part is drilling out the plug on the fuel screw. Be careful not to drill it out too deep to damage the screw. Set it out about 2 1/2 turns because they come too lean from the factory, then get it running and just set your idle.
current- 1982 Suzuki DR125
gone- 185 rear suspension frame, 200s motor. my hybrid 200/185x.
3 wheels are better than 4