**this only works with a normally open switch such as a pro design, pro armor switch, or any other open type switches**
ok, right before the coil there is a black cover looking thing with a bunch of wires in it. they all have quick connects.
1. find the black with a yellow stripe wire that comes from the coil (yellow arrow points to it).
2. disconnect it.
3. pull the boot back and push the long one in the boot with the plug.
4. wrap wire into plug so it touches good.
5. plug it back in.
6. ground out the short one to the bars or where ever you want.
7. mount to bars where you please.
note: you have to add some wire to the switch to make it all the way to the coil for the long one. this requires no cutting or anything to the wiring harness. if you take some time and do it right it is a 20 minute procedure. it is as easy as these 7 steps. then if you want to take it off it is very simple to do.
Click for bigger Diagram
Maybe if i get time i will do one on normally closed switches later and add it to this thread. steve
Reply With Quote