Results 1 to 5 of 5

Thread: Unhooking Oil Line

  1. 09-14-2009, 08:04 AM #1
    TODD T
    TODD T is offline Junior Member
    Send a message via Yahoo to TODD T
    Join Date
    Aug 2009
    Location
    BURNSVILLE, N.C
    Posts
    18

    Unhooking Oil Line

    HEY GUYS NEED SOME HELP HERE, I WANT TO MIX OIL AND GAS MYSELF CAN I JUST UNHOOK OIL LINE FROM OIL JUG? AND ALSO I NOTICED WIRES CONNECTED TO OIL JUG IS THIS A LOW OIL SENSOR?
    Reply With Quote Reply With Quote
  2. 09-14-2009, 09:24 AM #2
    Guest

    yes

    yes unhook line, wires and cut oil line to carb and block both lines from oil injection . Then u should be good to go.
    Reply With Quote Reply With Quote
  3. 09-15-2009, 07:31 AM #3
    TODD T
    TODD T is offline Junior Member
    Send a message via Yahoo to TODD T
    Join Date
    Aug 2009
    Location
    BURNSVILLE, N.C
    Posts
    18

    OIL LINE

    THANKS, ALSO WHATS A GOOD OIL GAS RATIO TO START WITH?
    Reply With Quote Reply With Quote
  4. 09-15-2009, 07:38 AM #4
    Guest

    OIL

    32:1 or 40:1 is a good starting point. Dont forget to block the oil intake to the carb. Thanks
    Reply With Quote Reply With Quote
  5. 09-15-2009, 08:27 PM #5
    TODD T
    TODD T is offline Junior Member
    Send a message via Yahoo to TODD T
    Join Date
    Aug 2009
    Location
    BURNSVILLE, N.C
    Posts
    18

    OIL LINE

    SO YOUR SAYING ITS OK TO DISCONNECT THE WIRES. AND JUST PLUG OFF OIL LINE GOING TO CARB?
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules