Well with the bowl off and the carb upside down and level there is a seam in the float where it was molded together almost dead center of the float. With it level that seam should be level with bottom of carb housing or just a tiny bit above level if the seam is hanging below then it needs adjusted!!
Xtreme Missouri Boyz
Finding the holes and rooting them OUT
06 Arctic Cat 400
29.5 Laws
Custom Exhaust w/snorks
2" Snorkels
/// Love!!
S/W secondary spring
Stall Springs
GWC'ified
-----------------------------
1992 Mojave 250 engine!! Work in progress!!