|
|
Senior Member
I just ordered a xr400 cam and a je 10.5:1 piston.I was talking to some one from eastcoast atv and was told that i had to change my rockers to run the xr cam that it is a hardened cam is this true if so it wouldnt be worth the money doing all that.Are there any things I need to watch out for when doing this change.
Senior Member
I don't think you have to do anything but drop it in.
2002 Yellow 400ex
Body
Renthal 14 tooth, LSR e-brake block off, Speed EZ Pull Clutch Lever, Pro Design kill switch, Renthal Handle Bars, Trail Tech Speedometer, AC Pro Pegs and Bumper, Houser +2 A-Arms, Elka Tripple Rates w/ rezzies, Elka shock covers, Razr MX's front and back, douglas ultimate beadlocks, Fastline Breaklines, Lonestar Axle.
Motor
J&E 12.5:1 piston, custom cam, valve springs, hardened rockers, race port\polish. Yoshi pipe, K&N jet kit and air filter.
STQRA Amature #6
My Quad Site
It may be helpful to rub some fine sandpaper or emerycloth across the rocker faces before you install the cam. Just scratching the face is good enough. Buy a XR400 head gasket to get 10.5:1 the EX gasket is thicker.
Posting Permissions
Reply With Quote