|
|
Marquette #6
i got an 04 z400 and i believe there is a problem in the wiring system sumwhere but not sure where at. if i turn my key and ignition on n let it sit there the clutch cable and lever n perch will get warm n hot if on long enough... does anybody have any ideas as to what culd be making it do this? never encountered this problem b4 so im stumped here...
Looking at getting a 400ex!
Registered User
a freind had a simmler problem ,but it was the starter button ,got so hot it melted a hole in it and burend a spot on his thumb.
we took it all apart use air pressure to blow it clean . not long after that he sold it
03 Z400
13:1 JE piston
95.5 bore
+5 stroke
RHC Ferrea valves +1 intakes
P&P
Barker performance pipe
no air box
dynatek cdi
05 trx450r air boot
42mm Sredrum TB fcr carb w//RAT 180&48@1000, 160&42@5000'
RHC cams #208 »
-16 flywheel
drz manual engine decompresser
06 clutch ,450r plates ,400ex springs
12 paddle 22x12x8 skat-trak TB exstreems (72 rollout)
Honda trx700xx, 751cc +3 stroke,+3 bore, +1 intake valves,
________________
Senior Member
About how long does it take to get hot?
2005 yfz450
-P.E.P Front shocks with oversized resivoirs
-Metal Craft Long travel a arms
-steering stabilizer
-Lonestare +4 axle
-Beadlock rear rims
-Pro design filter
-High Compression piston
-AC nerfs
-Blue frame
-Fat bars
-Taper Bored carb
-HMF Exhaust
Senior Member
Take starter apart sounds like wire is bare and touching perch will then burn hole and short out or weld it self to perch.
Posting Permissions
Reply With Quote