clutch hub removal on a 250x

[kicken250x]

I dont know if any of you remember or not but a while back i posted where my sleeve broke and hit the throw on the crank and thrashed it. It is in 1000000 peices in my bottom end. i funaly got the cyclinder off with a tortch some ice and 2 HUGE screw drivers. I got the sleeve and the poiston pressed out...well...what was left of it anyway. Now I have the motor sitting on 2 mike crates in my building. and i cant seem to get the hub bolt off...any suggestions? I tryed an impact wrench with no luck, I tryed holding the sprocket with vise girps and useing a torque wernch to turn the hub bolt and nothing. What else? And yes i unstaked it to. Thanks in advance for any help!

[kicken250x]

C'mon guys someone has to know!! I need help ASAP!!!




bump....................

[kc 300EX]

impact wrench is the best way to go

[kicken250x]

I tryed an impact wrench...nothin happend. Did even move the nut. It wouldnt happen to be reverse threads would it...?

[kc 300EX]

No its not reversed...........Impact wrench is still your best bet, keep trying

[kicken250x]

Ill be out there first thing tomorrow to try it again...Ill let you know what happens