Kill switch

Where can I buy a kill switch/tether for an 05 Eton Viper 90r?

[etondaddy]

Gary Fallon


Mike Kozura

Not sure who those people are...I assume maybe you are Mike?

[etondaddy]

Originally posted by p411m
Not sure who those people are...I assume maybe you are Mike?

Yes sir fat Mike here......

Go to Kyle's web page www.kylekozura.com there's a link to mini quad nation (Gary Fallon) on the home page.....coolest cat in the mini quad world.... he cares about the people he deals with and will get back to you quick. Tell him fat Mike told you to call.


Mike Kozura

thanks...Mike!

Is the Viper 90r a normally open or normally closed circuit? How do I connect the kill switch? Not good with electronics

[etondaddy]

Originally posted by p411m
Is the Viper 90r a normally open or normally closed circuit? How do I connect the kill switch? Not good with electronics

OK you have a stock wiring harness with a battery start.... right ?
then do this......... it don't mater if it's open or closed....just get a pro design and your good.

This is from Bulldog himself......well put...

No the aftermarket tether will not plug into the existing harness

Install:

1-Remove old tether and plug the male into female to complete the line

2- New tether
A)Take line that connects to the exposed metal part and attach to a ground.
B) Take the other lead and splice it into the hot lead on the coil

Originally posted by etondaddy
OK you have a stock wiring harness with a battery start.... right ?
then do this.........

This is from Bulldog himself......well put...

[red]No the aftermarket tether will not plug into the existing harness


Install:

1-Remove old tether and plug the male into female to complete the line

2- New tether
A)Take line that connects to the exposed metal part and attach to a ground.
B) Take the other lead and splice it into the hot lead on the coil (orange/peach wire)

All done[/red]

I have no old tether?

[etondaddy]

Ok then just disregaurd step #1

You sure I thought it was a law they had to have them......it's not behind the seat....


Mike Kozura

Can you explain part A) ? exposed metal part? Ground anywhere on the frame? and sorry for all the questions