Just put on the RAth hubs but it measures 50.5". Has any buddy had the same problem.
Just put on the RAth hubs but it measures 50.5". Has any buddy had the same problem.
i have some but haven't put them on. Daryl said he was going to make a spacer kit so you could fine tune the width more. i'll let him know about the width problem.
Thank you to my sponsors:
75 Designs, Rath Racing, FLY Racing, Fourwerx, Hinson, CP Pistons, Hoosier Tire, Atlas Brace, X Brand Goggles, Pivot Works, Motorex, H&H ATV, RynoPower, PRP
Thanks Patrickj75
All so the taper at the back of the hubs are not right they are to small in the ID or they are not chamfered deep enough.
OK fixed cut the tapper in the back of the hub to the right depth used a 1" spacer cut tapper to fit the axle measures 49 7/8".
Patrickj75 if you set the washer with the tapper on the back of the hub you will see if the tapper is deep enough.