Ok this is what I've found out. There are three wires coming out from the bottom, one dark green that runs up to the headlight, one light green with a red stripe that goes nowhere and a black one that runs to the coil and run switch. I used my multimeter and tested the run switch and it was good. I had the meter set on ohm with alarm to where it would buz when the probs made contact with each other(as you can tell I'm not real good with these meters). I than unpluged the black wire, touched a prob to it and the motor and got a signal(am I suposse to?) How do you check all of these parts and what do I need to set my meter to to do the test?