So it there a trick to keep the rollers from turning sideways after you clean em and put them back on bike. I'm getting it done but just thinking there must be a trick.
So it there a trick to keep the rollers from turning sideways after you clean em and put them back on bike. I'm getting it done but just thinking there must be a trick.
I use a dab of grease to hold em in place but it's really not needed.
Are you sure they are turning on installation??
They allways turn when you pull the hub off.
2000 GNC 5N\
2001 GNC 9N \ 40+ class
2004 GNC 9N /
2014 rock crusher "GO tortoise GO!"
2016 Byrd Rooster
Father of the "11" time National champion,and worlds fastest woman ATV racer
A few fast LT80's
250R~300cc's
300ex
350 Rancher
Kymco Mongoose
Survivor of the 12 Hours of ATV America 04 and 05
I was turning the quad on its side so it wasn't so low to the ground when I was working on it. then with it flat on its wheeles it went right on. I dont know if they are turning on installation or when I pulled em off to see if they turned when I put em on.
99.9% chance, it's on removal.
2000 GNC 5N\
2001 GNC 9N \ 40+ class
2004 GNC 9N /
2014 rock crusher "GO tortoise GO!"
2016 Byrd Rooster
Father of the "11" time National champion,and worlds fastest woman ATV racer
A few fast LT80's
250R~300cc's
300ex
350 Rancher
Kymco Mongoose
Survivor of the 12 Hours of ATV America 04 and 05