Need a Dimension. Rear Case bushing on YZ400-450F

[Groves187]

I am looking for the dimensions for the case bushing that the pivot bolt runs threw. I dont have any bushing in my motor to measure of off so I figured I would put up a post and see if anyone had a motor out they could measure them from. The only Dimension i need from this bushing is the lip that sticks out of the cases.

Here is a link to a parts finder that shows what i am talking about, They call it a "Collar" The # on the page is 23.

http://www.yamahaoftroy.com/fiche_section_detail.asp

Thanks, Nick

[ss440ex]

Mark Vette,
Do you happen to have an engine we can get a pic of and some measurements off of?
The rear bushing area where the pivot bolt goes through?
Need measurements of the OEM bushings.
Thanks.

[Groves187]

Al, I sent him a PM with no Reply, So I posted it also.

Nick

[markvette]

sorry been busy, kids birthday party today. ok the bushing sticks out .135 now that is not from the small recess the bushing fits in that is off the outside edge of the case. hope this is what you need.

Mark

[ss440ex]

I believe that is what he is looking for!!!

Thanks Mark.

Al

[Groves187]

Thanks A lot Mark. Thats what I was looking for.

Nick