ok ok i jsut am starting to wheelie. i can do it from 1rst gear from a take off but i dont know how to do it from differenr gears, is there a trick to it? i ahve a 400ex 2007 by the way. thanks to anyone that can help me.
ok ok i jsut am starting to wheelie. i can do it from 1rst gear from a take off but i dont know how to do it from differenr gears, is there a trick to it? i ahve a 400ex 2007 by the way. thanks to anyone that can help me.
Selling 2007 400ex!!! Check It Out!!!
http://www.exriders.com/vbb/showthread.php?s=&postid=3142014#post3142014
gas it and set far back on the seat and use the clutch and rear brake you will get the hang of it
05 450r
Houser stem, Denton Stabalizer, Moose Fatbars, Baldwin Hot Start Cable, Hot Rod Crank, Moose Billit Clutch Basket, Moose Easy Pull Clutch Lever, pro motion twist throttle, Lonestar Carrier, Blingstar Heel Guards, Pced Fame(Black), Pced subframe(Black), Pced swinger(Black), PRM chassis Skid, Maier Hood, front hipers
04 tld pred
Full hmf sport pipe, pro taper bars, um nerfs, itp rims, pced frame and subframe and a-arms ( orange), pced swing arm shock springs and steering stem (black), cycra handguards, motion pro twist throttle, ims bumper, dg grab bar, moose chassis and swinger skids, spyder grips, k&n filter, pro design kill switch, front itp t9 beadlocks, rear douglas ultimate beadlocks
I have and 03 Z400 and I can wheelie in the first 3 by just leaning back and gassing the hell out of it, no clutch involved.
2003 Z400
- Pro circuit T-4 pipe/jet kit
- Air box lid removed
- DG Nerfs
- Kenda Knarly XC Rear tires
Just keep practicing you"ll figure it out
2004 450r
Hmf Pipe
K&N airfilter
yeap its prtti simple once u get used to it . i have a 400ex and an ltr and the ltr is easier to keep up but the balance point is awkward. so i like the 400 more . i wheelied it even when the clutch was bad.... lol
2002 426ex
ac nerfs
hmf slip on
nstyle graphic kit
gripper seat cover(not installed)
21'' holeshots (front)
20'' irazr's(back)
fly alumalite bars
amr stage 2 revbox
dynojet jet kit
m80'd ltr 450
pw50 with a big bore kit