High resolution frame pics...

[JMann2380]

Very cool looking... pics are courtesy of the great guys at www.atvnation.com

http://www.bombquad.com/images/2008_..._frame_1hr.jpg
http://www.bombquad.com/images/2008_..._frame_2hr.jpg
http://www.bombquad.com/images/2008_..._frame_3hr.jpg
http://www.bombquad.com/images/2008_..._frame_4hr.jpg
http://www.bombquad.com/images/2008_..._frame_5hr.jpg
http://www.bombquad.com/images/2008_..._frame_6hr.jpg
http://www.bombquad.com/images/2008_..._frame_7hr.jpg
http://www.bombquad.com/images/2008_..._frame_8hr.jpg
http://www.bombquad.com/images/2008_..._frame_9hr.jpg
http://www.bombquad.com/images/2008_...frame_10hr.jpg

[swampfoxsc]

JMann2380, please check your PM's and/or email asap. Thanks.

[Robin Hood]

Looking great!

Might need to rethink whether to go for the LTR now or wait until this bad boy comes out.

[JMann2380]

Couple more frame pics from atvnation... man I hope this carries over to a redesign of the DS650...

http://www.bombquad.com/images/2008_...frame_11hr.jpg

http://www.bombquad.com/images/2008_...frame_12hr.jpg

[massdabate]

should be interesting to see if it holds up i was also thinking what if you wanted to powder coat the frame would those new fasteners be able to withstand the heat and cooling down with out coming loose cause metal expands an contracts under such elements

[ThePhantomRider]

Again, shouldn't be a problem as most of the fasteners are aluminum as well. Plus, and again I go back to the aerospace use, these hold up very well in extreme environmental conditions including high heat and extreme cold.

Shouldn't be a problem.


TPR

[TWISTED DINLI]

thats pretty cool that there isn't any welds.

[parkers30]

anyone else notice the a-arm, wave brake rotor, spindle and head in the back ground of the last picture? (woops I mean #11)

Lower a-arm looks like a cast aluminum piece