how did you extend your rear brake linkage for the longer swingarm?
did you just cut and weld?
this is for a kasea 90
how did you extend your rear brake linkage for the longer swingarm?
did you just cut and weld?
this is for a kasea 90
CT Racing/IMS-ROLL YFZ-450 (Red)
Duncan Racing/IMS-ROLL YFZ-450 (Blue)
I just bought a piece of 1/4" steel rod, bent it in a vice the same shape as the original (but with extra length of course), drilled the small hole for the cotter pin at the foot brake end, and used a tap and die set to add the adjusting threads to the other end. Works great!
i used a piece of allthread and it broke up by the 90 where the cotter pin goes....
did you bend it to a hard 90?
CT Racing/IMS-ROLL YFZ-450 (Red)
Duncan Racing/IMS-ROLL YFZ-450 (Blue)
I bent it just shy of a 90 bend. I started to use allthread, but ran into the same problem. The steel rod is much stronger and ended up looking just like the original.
Don't try to put a 90 degree bend in threaded rod without heating it or it will break off.