07 Yamaha Big Bear 400 with IRS

[Puzzled]

With the cost of used machines and the would be scammers on all the big classified sites I decided to go with a new machine. After reviewing all of the brands I decided on a Yamaha Big bear 400 with the new IRS.

Pictures from the Yamaha site

[Puzzled]

[Puzzled]

I ordered a Moose 60" plow, plow push tubes and mount kit Tuesday. The dealer called Wednesday to let me know it all came in. I spent a few hours this morning assembling the stuff.

The first and only snag I ran into was the mounting bracket. I ordered what the Moose salesman told me to as this is an 07 bike. Well he was off. The mounting bracket was considerably over sized and did not come close to lining up with anything. So with a few measurements in hand off I went.

This is the plate as it comes.

[Puzzled]

You can see here what I cut off. I followed the lines of the frame leaving some overhang.

[Puzzled]

Another with the cut pieces along side.

[Puzzled]

I had to enlarge the center hole to allow acess to the oil drain plug.

[Puzzled]

Initial trial fit.

[Puzzled]

With the way I mounted the mounting plate the bolts run in two directions. I felt this would add a little more strength to it, or not. The way the instructions show it mounted it utilizes the running board supports. I mounted it to the main frame rails and one of its cross members.

[Puzzled]

All mounted up with the bolts trimmed.

[Puzzled]

With the plow on (minus the winch) and some accessories I picked up yesterday.