has anyone tryed this,i have a blaster motor and a 250r roller and i think i have seen this done.it would ride and hold up alot better than the blaster chassis.i would like some input on the exhaust and mounts.
|
|
Senior Member
has anyone tryed this,i have a blaster motor and a 250r roller and i think i have seen this done.it would ride and hold up alot better than the blaster chassis.i would like some input on the exhaust and mounts.
Registered User
there nice but the engine needs some mods to power around the bigger frame..
Registered User
yes it has been done my good friend had a rath racing super blaster for a while, had a stroker crank and everything, you will need to modify the bottom rails on the 250r frame, have a custom pipe made and motor mounts, my buddies had a merrel long travel front end and a full leager rear end, used to be raced by cody anderson and daryl rath, hauled some major *****
'04 trx 450r
Champion,OMF,HRC Burgard, Lonestar, Kenda, Titan, Rath,works, streamline,x-factor,LRD ....etc...
ATV-MX, Go Big Or Go Home
Ya there fast and sick looking but alot of work.
"He who has the most money, goes the fastest"
www.Tri-valleyracing.com
Tri-Valley Racing 300ex
1993 GMC sonoma
1994 Lincoln Mark VIII street car
1996 Ford mustang gt drag car
Sponsors:
Cycle Pros
Bettencourt's
Tri-Valley Racing
Tri-Valley Repair
Starr's market
FMF
Factory 909
Socal/decal works
Hutch motorsports
Senior Member
my bro back in the 90s had a blaster motor in a suzuki q-racer 250 frame.
it worked well for him since hes to tall for the blaster.
he said it fell right into the suzuki frame dont know about a honda
Posting Permissions
Reply With Quote