Timbomoose Porting
Timbomoose Porting
'03 MOTO
Engine Speed
'03 MOTO
Very nice graphs.
What else has been done to it? Did you do any baseline runs? Just curious.
"It ain't what you don't know that gets you into trouble.
It's what you know for sure that just ain't so. "
--Mark Twain
Thank you.
I have runs of some of other Cdales with pipes, airboxes (boltons) with stock motors I could post. They were all done on this same dyno.
Timbomoose did the porting on my motor. Even though the head was beat up, he still got a bit of power out of it. Compression is around 12.6:1 (pump gas). Stock cams, stroker crank and CP piston. Anything else just ask. Also, if you see something that needs improvement, I'd appreciate the input. Thanx, wanablaze.
'03 MOTO
Ok,
Looking through the database, a stocker seems to make from 36-40rwhp depending on the pipe. From what I remember torque is around 28 ftlbs. However, it's not just the peak that changed, the whole area under the curve improved drastically.
Watching them tune this thing was pretty cool. Plugged the laptop in and then changed some fuel numbers in the mapping. Test and then adjust again. Repeat. No tools needed. I'm anxious to see how the new Zuk's will get tuned.
'03 MOTO
What size motor??,,, piston and stroke??
02 ATKannondale 478 Moto
DABs Magic, Falicon'd
TCS, AC's K&N
21" 8 paddle Hauler/Glider mix
21" 8 paddle Gliders
Ultimates, Mohawks
03 Athena 434z by DAB Racing
Dyna ignition, Hotcams, 40 FCR
WB Ti/Carbon pipe, Mohawks,
20" 8 Paddle Gliders, K&N no box
http://community.webshots.com/user/sandgod4 for your action shots..