Need a little help

**yamr6bike** · 05-20-2006, 10:03 PM

First off its a 2000 shee was tore apart the hole thing to paint and rebuilt the motor and make sure everthing was good. now there is a problem it has a hard time starting but will still start and run fine but has to be pop started or if ya kick the hell out of it for a while that will work too. DOES ANYONE HAVE A SOLUTION AND OR IDEA OF WHAT NEEDS TO BE DONE.......

**250r4life** · 05-21-2006, 02:35 AM

go through the carbs completely, both of them, one more time...

if it will be pull started, sounds to me like you need to get your carbs good and cleaned...

**yamr6bike** · 05-21-2006, 01:19 PM

I tried carbs from another shee that runs 100% and it still does it what now....

**250r4life** · 05-22-2006, 12:18 AM

why dont you elaborate a little further about what all has been done and what kind of troubleshooting you have already performed...

**st8jacket** · 05-23-2006, 06:14 PM

make sure all of your grounds to the frame are in contact with bare metel..You had just painted the frame..As far as I can remember the coil,and regulator is grounded...

**st8jacket** · 05-23-2006, 06:46 PM

make sure all of your grounds to the frame are in contact with bare metel..You had just painted the frame..As far as I can remember the coil,and regulator is grounded...

Thread: Need a little help

Thread Tools

Display

Need a little help

Posting Permissions