Does anyone have a falcon 70.4 mm billet crank in there bike? Once my motor wears out I am really considering one of these bad boys as long as the quality is there.
|
|
GLAMIS PIMP>>>
Does anyone have a falcon 70.4 mm billet crank in there bike? Once my motor wears out I am really considering one of these bad boys as long as the quality is there.
2000 yamaha bansee- SOLD IT!!
2005 honda 450R
full baldwin motorsports exhaust
40mm edelbrock carb
ESR air box eliminator with uni filter
athena 480 big bore kit
wiseco 12.5:1 97mm piston
procom revlimiter
stage 2 hotcam
head ported and matched
R&D high rev dual valve springs
skat trak haulers 8 paddle
skat trak mohawks up front
both on douglas blue lables
Senior Member
I have just put the Falicon crank in my 450r. Mine is the stock honda crank rebuilt and ballanced by Falicon. It also has the Falicon Knife rod. The quality is awsome and so far I would highly recomend using them.
450r
monster is fo sale
msn
clutt-225@hotmail.com
Senior Member
here is a close up of the crank
450r
monster is fo sale
msn
clutt-225@hotmail.com
Senior Member
doesn't appear to be anywhere close to my falicon crank . check out my chamferred journels and bluprinted setup
:
HIGHLY recommended crankshaft
--------------------------
...Having a blast on my 70HP Dynojet tuned 500R!
Senior Member
now that is a crank! I went with the rebuild of the stock honda crank do to $$$. They use a honda crank and balance it, and they use the knife rod wich is much better than the stocker. But if you have the money chad has the right idea.
450r
monster is fo sale
msn
clutt-225@hotmail.com
Posting Permissions
Reply With Quote