Results 1 to 2 of 2

Thread: starter one way bearing

  1. 02-26-2006, 06:01 PM #1
    hellrazors05
    hellrazors05 is offline Member
    Join Date
    Jan 2006
    Location
    macungie pa
    Posts
    33

    starter one way bearing

    ok guys i am pretty sure i am getting a 03 dale canninbal but it needs a starter one way bearing how hard is this to put in i have mechanical ability and work in a machine shop. this quad supposidly has all the upgrades done to it and stage 8 kit. so whats involved and is there an easy vs hard way proper vs stupid way. any help would be great. thanks Eric also what does this part cost and were can i get it
    Reply With Quote Reply With Quote
  2. 02-26-2006, 06:55 PM #2
    iceracer17
    iceracer17 is offline Y TRY
    Join Date
    Nov 2002
    Location
    wisconsin
    Posts
    396
    The one way requires pulling the motor and getting the crank plate out.If you are mechanically inclined and have a manual(whch can be found at c-dale riders) it's not to bad to do.Then you can check the rod bearing while it's apart.I think the bearing is around $35 at www.blackwidowatv.com
    11' grizzly 700
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules