I recently bought an almost stock 90 off Daryl Rath. What did you guys replace the lame handlebars with? I was thinking about some T2 mini bars, what levers?
Thanks
I recently bought an almost stock 90 off Daryl Rath. What did you guys replace the lame handlebars with? I was thinking about some T2 mini bars, what levers?
Thanks
levers and cables can be used off most mini bikes.
i tried replacing ours, but cody told me he would kick my rear end if i didnt put them back
Staff Photographer ATVRiders.com
Senior Photographer ATVInsider
Staff Photographer GNCC Racing/ATV MX
Staff Photographer Vurboffroad
Staff Photographer Cycle News
Pappy, you left the stock bars and levers?
cody runs stock, has for teh past 2 seasons.
we replace teh cables about twice a year but thats it. they are cheap, and has hard as he rides and wrecks, replacing them is gravy
Staff Photographer ATVRiders.com
Senior Photographer ATVInsider
Staff Photographer GNCC Racing/ATV MX
Staff Photographer Vurboffroad
Staff Photographer Cycle News
we will be adding flexxbars after some testing. i have a set here but have not had a chance to install them and get all the new levers etc. he is way past the point of the suspension so every little bit of help we can get will benefit us.
Staff Photographer ATVRiders.com
Senior Photographer ATVInsider
Staff Photographer GNCC Racing/ATV MX
Staff Photographer Vurboffroad
Staff Photographer Cycle News
YOU CAN USE MOST ANY BAR AS LONG As they are not to high because the cables wont reach. as for the levers i have been using msr cr80 clutch lever and perches on both sides and removing the adjuster
other
I have converted the front end to 300ex components so I needed a place to mount the master cylinder. My son likes the stock bars so I Dremeled the bracket off for the front brake lever.
did you go with the front end conversion i have seen on Ebay ?Originally posted by dirttrack71
I have converted the front end to 300ex components so I needed a place to mount the master cylinder. My son likes the stock bars so I Dremeled the bracket off for the front brake lever.
Dwayne
Yes, it is made by Diamond J products.