lots of misc..250r parts for sale some 400ex parts

[slamdak8782]

I just got an 89 250r. Over the years I collected quite a few parts for the 250r. Well here is what i'm selling

Stock axle with hubs and sprocket

400ex rear plastics yellow factory in new condition

stock 400ex shocks $50 plus shipping

250r frame modded to fit 350x engine so it will bolt in "make offer"

stock 250r steering stem black perfect condition $40 plus shippong

laegers swingarm stock length for 89 250r "make offer"

[slamdak8782]

i also have stock spindles in good condition for $65 plus shipping

stock twin row carrier in good condition I swapped it out for Rad tapered carrier $85 plus shipping

set of stock A arms for 250r good condition a couple of the arms have small tears in the boot but they still hold grease so they are overall average condition the ball joints are still good and they have homemade diamond plate guards on them these come with the tie rods as well. $100 everything is there so they will bolt on I even zip tied the ends so the spacer wouldnt fall out

I cant post pics because my camera takes pics bigger than we can post on here But I would be happy to send pics with e-mail

[doc-bones]

Interested in your Laeger swinger. Check your PM`s

[Chino886]

Originally posted by slamdak8782
I just got an 89 250r. Over the years I collected quite a few parts for the 250r. Well here is what i'm selling

Stock axle with hubs and sprocket

400ex rear plastics yellow factory in new condition

stock 400ex shocks $50 plus shipping

250r frame modded to fit 350x engine so it will bolt in "make offer"

stock 250r steering stem black perfect condition $40 plus shippong

laegers swingarm stock length for 89 250r "make offer"

got a 250r rotor, brake stay, rear caliper by any chance?

[slamdak8782]

I have a break stay if you are interested. I still have the rear caliper but it needs the slider and rubber gaskets to be functional again. When I got it I had some trouble putting the new pads in and I had to jb weld the threads for the slider pin I'll get you some pics if your interested

[slamdak8782]

Pics of the swinger

[slamdak8782]

shocks

[slamdak8782]

spindles

[slamdak8782]

Frame has been welded on. It will fit a 350x

[slamdak8782]

tank