Hey I'm wondering what the procedure is to polish stuff. Anybody know where an extensive artile is on it? Or want to give me one, or some tips or the basics?? thanks mitch
Hey I'm wondering what the procedure is to polish stuff. Anybody know where an extensive artile is on it? Or want to give me one, or some tips or the basics?? thanks mitch
Mitch
2003 Jb crf450
http://www.exriders.com/vbb/showthre...ight=polishing
Try using the search next time, there's been past how to's on this
00' 400EX - GT Thunder 450 stroker, custom JE 12.5:1 piston,
+7mm stroked crank, HD stroker rod, HRC cam, GTT full race porting, +1mm intake valves, FCR 39 carb, CRF timing chain, Denso IXG27 iridium plug, full Hinson 8 plate clutch, Desert Toyz Supercooler w/ SPAL fan, UM airbox w/ UNI, CT Hi-Output exhaust, Roll LOBO II F/R, LT PEP 8 click ZPS piggyback fronts, PEP ZPS rear, YFZ brakes/450R master, CCP stabilizer, Hiper Tech beadlocks, Durablue X-33, TAG, Quadtech, ASV, AC, IMS, RAD, Works Connection, Galfer..
05' Kawasaki KLX 110 - Fast 50's springs F/R, HRC cradle, Rox risers, FLY fatbars, NGK CR6HIX iridium plug, Twin Air filter
I did, i didn't find any good threads
Mitch
2003 Jb crf450
My bad then. Found that thread first try on the search for ya
00' 400EX - GT Thunder 450 stroker, custom JE 12.5:1 piston,
+7mm stroked crank, HD stroker rod, HRC cam, GTT full race porting, +1mm intake valves, FCR 39 carb, CRF timing chain, Denso IXG27 iridium plug, full Hinson 8 plate clutch, Desert Toyz Supercooler w/ SPAL fan, UM airbox w/ UNI, CT Hi-Output exhaust, Roll LOBO II F/R, LT PEP 8 click ZPS piggyback fronts, PEP ZPS rear, YFZ brakes/450R master, CCP stabilizer, Hiper Tech beadlocks, Durablue X-33, TAG, Quadtech, ASV, AC, IMS, RAD, Works Connection, Galfer..
05' Kawasaki KLX 110 - Fast 50's springs F/R, HRC cradle, Rox risers, FLY fatbars, NGK CR6HIX iridium plug, Twin Air filter
i no a lot of people that use a polishing compound, but i never have to good of luck with it. i prefer the good ole fashion way (a little time consuming though) of starting out with a 180 grit to clean it off real good and then slowly working my way up to 2000 grit. it always looks good in the end!
Jimmy
I want to polish some stuff on my bike. DO 450r shocks, like the piggybacks polish?? also will the cases of my bike?? how long will it last before I need to polish them again? thanks-mitch
Mitch
2003 Jb crf450
I've seen ressies done before, I dont know for sure if Hondas are aluminum or not.
Your cases will polish though, take a tip from my thing use a magnet to check which ones and which ones arent aluminum.
Pratice on your motor mounts first
there aluminum
how long does the polish last?
Mitch
2003 Jb crf450
repolish them every 2 weeks with mothers and a rag.