Keep Going or Stop

[400hondaex]

Should i keep going with this or does it look like crap. I think it scratches to much but i'll let you be the judge if that. Maybe i should switch my bit to a brass one instead of steel? Let me know what you think.

[jiggaman2401]

Keep going.. Start using a finer grit itll help with the scratches then your gonna wanna use a mothers polish on it to finish it up! Lots of elbow grease.. good luck!

[400hondaex]

Im not sanding it right yet. Im using a steel wire bit on my dremel it cleans it up faster. Thats why im getting all those scratches. You think I should go back over it with 1600 grit when im done to take the scratches out or just leave them?

[jiggaman2401]

Well your def gonna wanna hit it up with the sand paper.. It will for sure take the scratches out.. Then when done hit it really good with mothers polish and it should come out real nice.

[400hondaex]

Cool I just hope I can fit this sob in those cooling fins other wise its gonna look like crap

[jiggaman2401]

Yeah man good luck with it.. let me know how ya did! Show pics to when your done or got problems..

[400hondaex]

Thanks sure will

[400hondaex]

Heres the valve cover almost done with the dermel. What do you think? I wish I didn't know what I got into Do you think it looks better than the cases?

[jiggaman2401]

nah it looks good the sanding will help with all those imperfections left by the dremel..

[400hondaex]

I tried 1600 grit and it didn't do crap. I might get some sanding bits for the dremel then go back over it with the 1600 grit. Only prob is the sand paper is hard to get around in the tight areas. Any input?