about how much powder would i need to do EACH part?
nerfs?
arms?
stock swinger?
about how much powder would i need to do EACH part?
nerfs?
arms?
stock swinger?
2002 400ex
Burgard,PEP,AC,K&N,White Bros,Pro Taper,Duncan,Maier,Cycra,ITP,Radial,RPM,Galfer,Pro Design,Scott
SOLD
1988 250x
Renthal,Acerbis,Tamers,Radials,Burgard,Douglas,+2a rms,Stream line,Uni,DMC,Duncan,Moose,Weisco, White Bros
also if i was doing my hubs....do i have to take the studs out? if so how do i take them out n reinstall them?
2002 400ex
Burgard,PEP,AC,K&N,White Bros,Pro Taper,Duncan,Maier,Cycra,ITP,Radial,RPM,Galfer,Pro Design,Scott
SOLD
1988 250x
Renthal,Acerbis,Tamers,Radials,Burgard,Douglas,+2a rms,Stream line,Uni,DMC,Duncan,Moose,Weisco, White Bros
it really depends on the color....
id say a pound for each to be on the safe side, then you will have extra when your done.
you dont have to remove the studs, tape them off with green tape and your good to go.
Staff Photographer ATVRiders.com
Senior Photographer ATVInsider
Staff Photographer GNCC Racing/ATV MX
Staff Photographer Vurboffroad
Staff Photographer Cycle News