400ex hard? like stripping it down to the frame?
( sry this is in open, didnt know where to put it)
Thanks
400ex hard? like stripping it down to the frame?
( sry this is in open, didnt know where to put it)
Thanks
2001 440ex
rebuilding as the paychecks keep comming in...
not realy....just make sure you put all the bolts that go to a specific part in a plastic bag...label it..and put it with the part, or tape it to the part...to keep it all organized.
they key to it is patience...you will run into a few problems..so just take your time
yea i think my olny problem is gonna be all the electrical
2001 440ex
rebuilding as the paychecks keep comming in...
electical isnt bad....the wires are color coded..its pretty much idiot proof
i have to change out frames with my 450r pretty soon..never done such a project before..it will be interesting
I had my 400ex tore down to only the frame with the motor out in about 7 hours, and that's with NO power tools..
I did mine in about 2, with power tools,Originally posted by Rico
I had my 400ex tore down to only the frame with the motor out in about 7 hours, and that's with NO power tools..
2007 yfz450
2011 rancher fpm
did any body have problem getting the swingarm bolt out, for me it was a b!tch
2006 TRX450er
nope, air hammers are a great thing.
2001 400ex
2003 Argo Bigfoot
if you had trouble, its probably bent. mine was bent so bad one time, i had to get the cutting torch out, impact hammers wouldnt touch it
"You say that I sin, You say I'm bound for hell, but once your judgement condemns you, I shall see you there."
----Georgia Southern University
-Logistics & Intermodal Trans.
Sinkhole Customs(choppers and 4X4)-mechanic/fabricator
sinkholecustoms.com
-Bronze level Honda technician