Results 1 to 3 of 3

Thread: LSR ball joints

  1. #1
    Join Date
    Oct 2002
    Location
    manteca, ca
    Posts
    549

    LSR ball joints

    I need to replace one of the ball joints on my LSR a arms. Do I need to order it from LSR or is there some place else I can get them? How much do they cost normally?
    2002 yellow 416ex
    Ross Piston 11:1 compression
    Hotcams stage 2
    Porting
    Spark's X-6 exhaust
    FCR 39mm carb
    165 main jet/ 52 pilot jet
    LSR +2 A-arms
    LSR +4 axle
    Elka tripple rate fronts
    Derisi rebuild rear shock
    Spark's rev limiter
    K&N Filter/Outerware
    Tinner Air Scoop
    Holeshot XCR on stock rims
    Tag T-2 handlebars

  2. #2
    Join Date
    May 2002
    Location
    Who the hell knows
    Posts
    65,589
    LSR uses a 16mm diameter shaft and unless you get lucky and get a parts store to match it you will need to get it direct from LSR.
    Staff Photographer ATVRiders.com
    Senior Photographer ATVInsider
    Staff Photographer GNCC Racing/ATV MX
    Staff Photographer Vurboffroad
    Staff Photographer Cycle News

  3. #3
    Join Date
    Apr 2002
    Location
    Nampa,Idaho
    Posts
    1,267
    Lonestar uses a 79 ford courier tie rod end for a ball joint.
    2006 LTR450 Almost stock and love it.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •