Hopefully someone can help me out there... I just replaced the front brake pads on my quad and now the front wheels are locking up. If I pull the front brake they will just stay up against the rotor except the inside one just gets pressed harder into it. The outside one seems to be rubbing all the time or close to it if it isnt. Only the inside pad seems to be moving but it still is pretty locked into place against thr rotor unless I pry it off with a screwdriver and compress the piston. When I did take the gold allen bolts/pins out of the front that hold the pads on I did notice that the gold finish was worn off in the middle but I dont think that would have that much of an impact, plus I greased the pins before I put them back through the pads... I dont know if I am explaining this clear enough, but they didnt drag at all when the pads were shot, and now they do, and I mean BAD. I need help guys, Im trying to get this together for a race and dont want to be forced to just throw the shot pads back on for now....