When i was changing the axle bearing, one came out fine, and the other came out in pieces, one half of the bearing is stuck in the carrier, how can I get it outt>?
When i was changing the axle bearing, one came out fine, and the other came out in pieces, one half of the bearing is stuck in the carrier, how can I get it outt>?
426ex.. sold
Well you listen to me you get your dremel and grind it out like i told you when i was over.
Lmt racing
We powdercoat!!!! For custom powdercoating please Email Bigdog6718@hotmail.com.
#4x-00'Red Skin 416ex- Trick to the bone.
You were as fast as me....
Until the green flag dropped
If you do not want to cut it out you will need a bearing/bear puller.
You should find one at the local auto parts store.
Some sort of penetrating oil would not hurt either.
I assume you have the outer race only stuck in your bearing carrier. Your buddy is right, a Dremel or preferably a die grinder with a burr type bit will cut through it and allow you to get it out. Be careful not to get into the aluminum of the bearing carrier. I have had to do this to my rear bearing once and recently to one of my front wheel bearings. I re-install them with a little anti-seize compound so hopefully next time they will come out easier.
You can alway lightly heat the race with a torch and then tap it right out. Always works for me. Don't tap the carrier it will break!
"99" 400ex
"03" 300ex
"07" LTZ 400
Original Jackazz riders